Product Description：

---

HTR is a solvent-based one-component screen printing ink, containing high-temperature resistant thermoplastic resin with high light and a good rub of wear. With Noriphan? HTR ink thermoplastic film may be forming. Can be used to Maokrofol and Bayfol film on a (PC material). Appearance: High light, gloss, printed material by the impact.
Color: Basic by high brightness and pigment composition of the transparent, almost all the colors can be obtained through the basic colors.
Basic colors: Color Varnish HTR Color 093 orange 212 yellow 112 and 171 (in the United States do not have this number) 308 and 318 red and 472 blue 566 purple 412 brown 812 green 669 white 945 black 952 4-color: color HTR-color Huang, No. 156, Green 558 Magenta 357 Black 949 Varnish 099
additives:
diluent / slow dry agents: select (evaporation rate from fast to slow)
diluent Noriphan? HTR 090
slow dry agents Noriphan? HTR 097
slow dry agents Noriphan? HTR 097/001 all solvents can be mixed in different ratios to achieve the desired drying rate, Noriphan? HTR 097 most widely used, printed fine lines, the slow dry agent Noriphan? HTR 097/001. Network Halftone: Available gloss Noriphan? HTR 099 four-color ink viscosity adjustment.
Printing:
Screen: Polyester mesh 90-150 mesh / cm (230-380 mesh / inch)
stencil to be anti-solvent, silicon materials will affect the printing, be avoided.
Dilution: Dosage is as follows: Noriphan? HTR Color Thinner 112 up to 2% of 093 up to 15% print results were affected by many factors, the proposed first launch a pilot.
Printing Viscosity: Viscosity adjustment can cause improper eye of a needle and leveling poor.
Substrate effects: the surface of dirty film will affect the printing, the need to avoid.
Influx also affect the film too much, they should first clean with alcohol after the drying film.
Copies: Available Aquapress (water) on their copy.
Cleaning: Screen and instruments available Proll-Uni-Rein cleaning
Drying: It is the physical drying system is available through solvent evaporation in the drying Road fast drying.
Adhesion: film / ink / resin adhesion due to a number of different factors will be different (such as product, process and product design), therefore, for each product are subject to separate tests.